Stand up for your right to repair! Well I took apart my NV52 and adjusted the cable as best as I could and shorted the board to get it started when I could and well the issue is now it starts every time but shuts off every 15 seconds on the dot. Problem is i get nothing on the display at all. All I did was pop the button out, play with it a little and put it back in. Now, it won’t power on unless the wires are pulled tight, which is weird. We do sincerely hope that you will be satisfied with our products and services.

Uploader: Samugore
Date Added: 28 May 2013
File Size: 20.98 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 13600
Price: Free* [*Free Regsitration Required]

I basically cannot figure out what happened. But nv52 issue it will boot, go from secs max and then shuts down. nv52

Mystery problem gateway nv52 laptop – Forums – CNET

This should be recalled by Gateway. I am replacing both nv52 to make sure. Once that is off: Now I nv52 to narrow it down nv52 the power button itself, see whether it’s the cable, spring, contacts, etc and go from there I found the large nv52 flat cable that powers the alert center and found it to be nv522 in several places.

Once in a while you find a nv52 be tech that can’t nv52 suspect parts. Nv52 took the spring out of the picture, just pushing the button board itself not attached to the spring power button. Wireless network device doesn’t work. With so many variations in memory, it’s important to understand just exactly what will work — and what won’t nv52 in your system.

See Also  RIKOMAGIC MK802 IIIS USB DRIVER FOR WINDOWS 7

This allowed me to remove the screen bezel and gain access to the power button and the cable connector. I installed the button right-side nv52 so the cable did nv52 make any bend at all. Also shop in Also shop in.

And is now retired. I tried booting from my Windows 7 disk just to do a clean install and even than nv52 refuses to work. This is a once-in-a-generation chance to protect local repair jobs—the corner mom-and-pop repair shops that keep getting squeezed out by manufacturers.

Is it all related to the button? Took nv2 battery out and plugged it in, nothing. I don’t see a mechanical switch. You nv52 posting a reply nv52 I’ve narrowed it down to the power button itself. Try the nv5 process with the cable going to the button completely nv52 at nv52 system board side, then try shorting out those pins again. This repair service covers the repair of your laptop logic board or motherboard only.

Mystery problem gateway nv52 laptop

It looked like Gateway installed the button upside down which forced the cable exiting the connector to make a sharp degree bend. This is the only main board. I had exactly the same problem. Just a thought nv52 had, but i do not nv52 the method in which this nv52 does this or where it located.

See Also  DRIVER: NVIDIA NFORCE MCP NETWORK ADAPTER

Without a doubt, compatibility is the most important factor in buying a memory upgrade for your laptop or nv52. I have had this issue almost since owning this laptop. Its hard to determine givin i wasnt near the nv522 at the time. I nv52 an NV52 that I can’t get on. No nv52, Even if I boot to Bios and let it sit, will shutdown. Well I took n52 my NV52 and adjusted nv52 cable as best as I could and shorted the board nv52 get it started nv2 I could and well the issue is now it starts every time but shuts off every 15 seconds on the nv52.

You are reporting the following post: Anyway, I closed the lid one night before bed, as normal, with it plugged into the wall.